1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

Any cement finishers out there?

Discussion in 'Landscape Architecture and Design' started by 1MajorTom, Oct 30, 2002.

  1. 1MajorTom

    1MajorTom Senior Moderator
    Posts: 6,074

    Not sure what forum I should place this in, and if it is applicable here, but here goes....

    For concrete work.
    What would give a cleaner finished appearance?

    White arrowhead expansion joints, saw cuts, or notched in by trowel?
    This will be for a sidewalk surrounding an inground pool.
    Sidewalk will be 36 inches wide.

    Thoughts from those that have used either methods are appreciated.
     
  2. Heller Landscaping

    Heller Landscaping LawnSite Member
    Posts: 204

    Notch it with proper expansion groove joint trowel.:)
     
  3. PAPS

    PAPS LawnSite Senior Member
    Posts: 404

    yea... def. joint trowel
     
  4. Guido

    Guido LawnSite Silver Member
    Posts: 2,085

    I would either cut and seal them or use a joiner. Joiner is the quicker route. I don't like the plastic joints for around the pool just in case they raise up a little, you'll start stubbing toes.
     

Share This Page