Anyone using thenew g6 blades

Discussion in 'Lawn Mowing' started by jmorgan71587, Jun 28, 2011.

  1. Green-Man

    Green-Man LawnSite Bronze Member
    Posts: 1,063

    I got it! :clapping: Thanks now I know what to be looking for. Tomorrow when I'm done mowing I will take a blade off and measure the center hole and see what it is so I can purchase those blades as soon as possible!!!!
     
  2. Ridin' Green

    Ridin' Green LawnSite Fanatic
    Male, from Michigan
    Posts: 13,313

    I know they show this on their site, but in case you missed it, make sure to also measure your blade from tip to tip diagonally- tip of the cutting edge at one end to tip of the sail at the other end. Not all blades for a given deck size are the same length due to where the spindles are mounted on the deck's top from brand to brand (and even within brands that have more than one style of deck of the same length), so make sure you also know that measurement when looking up blades.
     
  3. PLS-Tx

    PLS-Tx LawnSite Silver Member
    from Texas
    Posts: 2,385

    Anyone know the part # for 61" Ferris ICD deck?

    I want to try the G6, I sure hope they will help cut down on double cutting. We have had a lot of rain here this year and more on the way this weekend and next week.

    Also, where is the best place to order them from?

    Thanks
     
  4. grassmasterswilson

    grassmasterswilson LawnSite Platinum Member
    from nc
    Posts: 4,515

    Curious if anyone knows the price for a 60" hustler x-1. Looked ten up on jacks small engine and they were $27.27 per blade.

    This about right? Anywhere else to check?
    Posted via Mobile Device
     
  5. Richard Martin

    Richard Martin LawnSite Fanatic
    Posts: 14,700

  6. grassmasterswilson

    grassmasterswilson LawnSite Platinum Member
    from nc
    Posts: 4,515

  7. cimkill

    cimkill LawnSite Senior Member
    Posts: 271

    Here is the part# org 396-727
     
  8. Oregon OEP

    Oregon OEP Sponsor
    Posts: 142

    There are around 60 new G5 blades scheduled to release sometime in October. I will pass on more information next month.
     
  9. Ridin' Green

    Ridin' Green LawnSite Fanatic
    Male, from Michigan
    Posts: 13,313

    Great! Thanks for the update Dennis.
     
  10. Green-Man

    Green-Man LawnSite Bronze Member
    Posts: 1,063

    Cool! It wouldn't hurt to test those out as well!
     

Share This Page