B&S 14HP Vanguard OHV valve adjust

Discussion in 'Mechanic and Repair' started by marcinst, May 11, 2002.

  1. marcinst

    marcinst LawnSite Member
    Posts: 1

    Does anyone know the procedure for adjeusting the the valves on this engine. I have the specs but I'm not sure how to position the valves/engine for adjustment. Also which side do I measure at - the valve spring or the rocker arm side with the push rod.
     
  2. bwiesner

    bwiesner LawnSite Member
    Posts: 16

    Take the plug out and turn the engine over to top dead center (TDC) on the compression stroke. Take a long skinny screw drive and stick in the spark plug hole and turn over until the piston is 1/4 inch past TDC. Adjust the clearance on the valve side of the rocker arms. Later Butch
     

Share This Page