belts sticking

Discussion in 'Mechanic and Repair' started by ajordan193, May 29, 2006.

  1. ajordan193

    ajordan193 LawnSite Senior Member
    from WNY
    Posts: 460

    on my gravely walkbehind pro1336g the belts seem to stick when i make turns. How can i adjust this? Thanks in advance.

    -Andrew
     
  2. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,022

    Can you give a little more detail as what you mean by the belts sticking ?
     
  3. ajordan193

    ajordan193 LawnSite Senior Member
    from WNY
    Posts: 460

    belts sticking as in when i go to turn and tighten the belts i let off and they are still tight. Sometimes in order to get them loose you have to pry it apart with your fingers. Hope this helps more...

    -Andrew
     
  4. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,022

    Below is the break down on a Pro drive system, Check bushing #3 and make sure plate #4 moves freely on it. I have seen these rust and corrode and cause the problem you have. If this is not the system you have post all model numbers off your power unit.

    Gravley Pro Clutch.JPG
     

Share This Page