Blade cutting angle

Discussion in 'Hustler Turf Equip (Archived)' started by nkahootz, Aug 11, 2010.

  1. nkahootz

    nkahootz LawnSite Member
    Posts: 5

    I'm trying to build a blade grinding table. Can some one tell me what the correct degree of angle of the cutting edge is ?:confused:
  2. Mickhippy

    Mickhippy LawnSite Platinum Member
    Posts: 4,251

    30〫 Is what most use I believe!
  3. mowerconsultant

    mowerconsultant LawnSite Fanatic
    Male, from Syracuse, NY
    Posts: 9,761

    I dont have the angle, let me see if I can find out in the am.

  4. gps_jetskier

    gps_jetskier LawnSite Senior Member
    Posts: 303

    Funny you are building a grinding table. I've been thinking about doing the same thing. A snag grinder just dumps a bunch of heat into the tips and doesn't do a very good job. With our grinder I could just set it and let it go too. Come back and they're done.

Share This Page