Blade setup suggestions for Lazer Z HP

Discussion in 'Homeowner Assistance Forum' started by brucec32, Jul 20, 2003.

  1. brucec32

    brucec32 LawnSite Platinum Member
    Posts: 4,403

    I have a 48" lazer z hp with the 21hp Kawasaki engine which is torquier than the Kohler units. After using a full size lazer loaner I have noticed that the cut in tall grass could be a little better. So, has anyone found an ideal blade setup for use on Lazers they would like to share?

    I have two sets of gator type blades, plus loads of stock high lifts. One of the gator sets foils is turned in, the other out.

    I've heard some say a set of gators over a set of high lifts works good.

    Any suggestions?
     

Share This Page