1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

Blades not engaging

Discussion in 'Mechanic and Repair' started by MisterGreen, May 16, 2006.

  1. MisterGreen

    MisterGreen LawnSite Member
    from Kansas
    Posts: 23

    Wright Stander 61" 25hp
    Problem: Mower goes off whenever we engage the blades.
    We already check the area where we stand up to ensure there is nothing stuck there. Tks
  2. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,023

    Check your operator presence switches (Safety switches) Sounds like one is not working.
  3. fireman649

    fireman649 LawnSite Member
    Posts: 76

    I just had the same problem on a 36" wright stander. The relay that is on the right side if your standing on the back is bad. The one I worked on, you could smell it, it was burned up, put a new one on, worked great. It was located on the right side frame rail almost near the deck. Hope this helps.


Share This Page