1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

Bobcat

Discussion in 'Mechanic and Repair' started by ohiododge, Jan 14, 2012.

  1. ohiododge

    ohiododge LawnSite Member
    Posts: 6

    Hello, Well 2 questions for the group. 1. What are the specs for the 5 screws that hold the recoil starter cover on the 15hp kohler? PO lost all of them!
    2. Rebuilt the peerless trans as the input needle bearings were toast, Add the benotite grease before putting halves together or add it after? 700 series trans.
     
  2. ohiododge

    ohiododge LawnSite Member
    Posts: 6

    Well seems as I didn't get any input here is the answers. Screws are a 10-32 and fill the case up first then clean area around seal and use loctite gasket stuff. All good just rebuilt my peerless and works great. Better than 200.00 dollar new one.
     

Share This Page