Calculating Stone

Discussion in 'Landscape Architecture and Design' started by WEEDEATER, Jan 30, 2003.

  1. WEEDEATER

    WEEDEATER LawnSite Member
    Posts: 48

    I'm looking at installing 3/4 "- 1" landscape stone in a bed that's 30' x 50' ,2" thick. Do you use the same calculations as installing mulch? 1500 sq ft = ~ 10 yds of stone.
     
  2. AGLA

    AGLA LawnSite Bronze Member
    Posts: 1,740

    Go heavier than mulch because a true 1" of 3/4 is going to have lots of holes in it. ...you know what I mean?

    It is like measuring a three foot tall wall using length and height for square footage only to find that your blocks are 8" high (36" does not divide evenly by 8)...you need more square footage of block to make the wall.

    3/4 will look sparse at 1".
     
  3. E-man

    E-man LawnSite Member
    from PA
    Posts: 136

    You are probably looking at 75 to 100 square feet per ton .
     
  4. Tim Canavan

    Tim Canavan LawnSite Member
    from Houston
    Posts: 218

    what kind of stone?
     
  5. GarPA

    GarPA LawnSite Silver Member
    from PA
    Posts: 2,585

    i find about 100 ft per ton works at about 1.5 inhces...you want to put only as much on as needed...no more..and make sure theres heay landscape fabric underneath...something heavier than the std mickey mouse weed barrier that Home Creapo sells
     
  6. WEEDEATER

    WEEDEATER LawnSite Member
    Posts: 48

    The stone is a Ruby Red kind of granite. Do you think i should increase it to 13 yards with 11 hours labors for two guys. I'm going to be putting down a heavy fabric first, removing the mulch and installing some edging with 4 hours labor. What do you guys think, sound close?
     
  7. GarPA

    GarPA LawnSite Silver Member
    from PA
    Posts: 2,585

    I;m a little confused....so start to finish...how many total manhours are you estimating...?
     
  8. WEEDEATER

    WEEDEATER LawnSite Member
    Posts: 48

    My guess is to hand rake existing mulch from area to be covered in stone, remove old torn fabric, replace with new fabric, add 20 ft of plastic edging, buy the product, one guy 4 hours.

    Two guys - shovels and wheelbarrows walking 100 ft each way, 13 yards of Ruby Red granite 1" stone to cover an area 30' x 50' = 1500 Sq Ft. 2 inches thick = 11 hours labor.

    Does this not seem correct? What am I missing?
     
  9. Turfdude

    Turfdude LawnSite Bronze Member
    Posts: 1,900

    1 ton of 3/4" stone will cover approx 100 sq ft to a 2" depth
    50X30= 1500 sq ft. so get 15 Ton of stone.

    Bob
     
  10. WEEDEATER

    WEEDEATER LawnSite Member
    Posts: 48

    What's your guess for amount of time using a bobcat vs using wheelbarrows and shovels.
     

Share This Page