changing blades

Discussion in 'Mechanic and Repair' started by dlreese, Apr 24, 2003.

  1. dlreese

    dlreese LawnSite Member
    Posts: 3

    How do you change the 3 blades on a Wright Stander?
     
  2. SCAPEASAURUSREX

    SCAPEASAURUSREX LawnSite Senior Member
    Posts: 835

    ??? I am not too familiar with a wright stander but would think it's set up the same as any machine... Just jack up the deck however you would, On a walk behind I lift by hand and support with a jack stand, Maybe you cant do this with a stander cause of the center of gravity ?? But I have heard of some guy s pulling machines up on the trailer ramp half hanging off to change the blades... ?? dont know if this would be safe or not ?? Also there are tools for raising the deck of machines ? not sure of brands , but i think trimmer trap makes one ?? ??? I am guessing that the deck does not tilt up in position ?? Did you check the owners manual ?? call you dealer too , they may have the suggestion for you to do it safely ?? I could see it would be tricky with that type of setup , but it's got to be done somehow........Or maybe you can just buy a new mahcine every 10 hours LOL...
     

Share This Page