Chevy Trucks

Discussion in '<a href=http://www.plowsite.com target=_blank ?>Sn' started by firedog, Sep 27, 2000.

  1. firedog

    firedog LawnSite Member
    Posts: 68

    Any one use a 2wd 3500 dump truck to plow. I have a 94 with a 350 and it plows great, my problem is the front end height. I have put heavy springs on the front along with timberlins (sorry for the spelling) and the plow still hits on the truck frame to the ground. the frame is all the way up. Oh yea its a western unimount. I can't find a lift kit for that truck. Any help?
     
  2. plowking35

    plowking35 LawnSite Bronze Member
    from S.E. CT
    Posts: 1,687

    sorry dude, that is the way they make em, the 4x4's arent much better.
    Dino
     
  3. firedog

    firedog LawnSite Member
    Posts: 68

    I know if the truck wasn't in great shape I'd get a different one. Too much$$$ in to it.
     
  4. JCurtis

    JCurtis LawnSite Senior Member
    Posts: 292

    2wd??? ewwwwwwwwwwwwwwwwwwww!!!!!!

    Just joking... I used to plow with a 1973 2wd International Lowboy dump.Was ugly as sin, but it had real power.

    Seriously 4wd is much better (especially Chevys) They are all I run... Pulled a lot of fords out of not so deep snow. don't know if it was the trucks or the drivers, but I am willing to split the difference 50/50

    As far as the frame is it one of those that goes to mid cab? Thats what the IH I drove had.

    If thats the case, you could always opt for a different plow manufacturer. The plow is cheaper to replace than the truck!!!!
     

Share This Page