Conversation with Griswold Controls

Discussion in 'Irrigation' started by FIMCO-MEISTER, Oct 20, 2010.

  1. Mike Leary

    Mike Leary LawnSite Fanatic
    Posts: 21,909

    Does that just break the common and shut the whole system down?
     
  2. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Posts: 47,363

    How can you shut down a normally open valve by breaking the common? :confused:
     
  3. Mike Leary

    Mike Leary LawnSite Fanatic
    Posts: 21,909

    Trick question, thanks for blowing it. :hammerhead:
     
  4. SoCalLandscapeMgmt

    SoCalLandscapeMgmt LawnSite Bronze Member
    Posts: 1,800

    No. The unit is fully programmable with both N.O and N.C. relays. You can set all kinds of different parameters to control how the unit responds to the flow data and how and when the unit will reset it self. It's pretty slick. We've had them on a couple of jobs. You have to program them from a Windows based PC.
     
  5. Mike Leary

    Mike Leary LawnSite Fanatic
    Posts: 21,909

    Link?.............
     
  6. SoCalLandscapeMgmt

    SoCalLandscapeMgmt LawnSite Bronze Member
    Posts: 1,800

  7. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Posts: 47,363

    Badger? Uh-oh..... ;)
     
  8. Power to ya mike. I wouldn't open a nc master valve unless i knew the line was fully charged without opening a zone valve. NO mv is a different matter.

    My guess is your N. O. Existed for your convenience not for emergency shut down through a flow sensor.
    Posted via Mobile Device
     
  9. Never have obviously. Is their a story with this?
    Posted via Mobile Device
     
  10. Mike Leary

    Mike Leary LawnSite Fanatic
    Posts: 21,909

    Thanks, Dan. I did not know something like that existed; leave it to Data Industrial/Badger to come up with that. Too bad it won't work on my Mac. :cry:
     

Share This Page