craftsman bagger fits my Exmark

Discussion in 'Lawn Mowing' started by turfman59, Nov 2, 2003.

  1. turfman59

    turfman59 LawnSite Senior Member
    Posts: 801

    Hate to even admit it but my Exmark 23/60 accepts the bagger off my old crapsman didnt even need to drill it out. All I had to do was add a 3 ft pc of pipe where it came up short. Works great too. as long as the leaves are a little dry it sucks'me right up. Run through the thick ones first with the Ransome with the gators and follow with the lazer and Whola clean as a whistle, This is gonna be fun fron now on
     
  2. locutus

    locutus LawnSite Bronze Member
    from NC
    Posts: 1,266

    Where did the three foot piece of pipe go?This statement has the makings of an off-handed joke, but I'm curious to know how the three foot pipe fits in. Damn, I did it again!
     
  3. John Gamba

    John Gamba LawnSite Fanatic
    from ct
    Posts: 10,812

    LOLOLOLOLOLOLOOL.
    John
     
  4. turfman59

    turfman59 LawnSite Senior Member
    Posts: 801

    John go ahead and laugh!
    the freakin thing works, you should have seen the grin on my face.
    A ultra vac would be nice but Iam on a budget. Well maybe just a cheap SOB
    The only bad thing is it doesnt have 3 bags

    the 3 foot pc of pipe is the same kind of pipe they use on the ferris bagger systems UDF vacum tube From Grand Rapids Rubber
    it just fits over the crapsman bagging tube in between there is a gap should I take a picture.

    John tell me where I can get a peco blower?
     
  5. John Gamba

    John Gamba LawnSite Fanatic
    from ct
    Posts: 10,812

    I'm not laughing at you, I just think it's cute :D . I've never owned a peco?
    John
     
  6. turfman59

    turfman59 LawnSite Senior Member
    Posts: 801

    No John, cute would be, The bagger on the Crapsman.
     
  7. John Gamba

    John Gamba LawnSite Fanatic
    from ct
    Posts: 10,812

    :laugh: :laugh:
     

Share This Page