1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

Customers want different cut heights what to do on site.

Discussion in 'Lawn Mowing' started by Rll131, Jun 22, 2013.

  1. inHaliburton

    inHaliburton LawnSite Member
    Posts: 196

    Thanks, fellas.
  2. Rll131

    Rll131 LawnSite Member
    Posts: 133

    Ended up selling it and got a floating deck soooooooo much better so glad I did cost a decent amount more though.
  3. LifeBack Lawns

    LifeBack Lawns LawnSite Member
    Posts: 216

    They are a bit more, but worth every penny. It will make up for the time adjusting spacers and such. You will probably get it back in a couple months. By the way, what did you end up getting?
  4. OakNut

    OakNut LawnSite Platinum Member
    Posts: 4,051

    Height adjustment was one of the reasons I bought a Ferris.


    Just give those cranks a few twists and you've got your adjustment - in ANY increment you desire - not just "notches" to pre-set heights.

  5. inHaliburton

    inHaliburton LawnSite Member
    Posts: 196

    Nice piece of equipment.
  6. 123hotdog

    123hotdog LawnSite Senior Member
    Posts: 481

    Two things have cost me allot of lawns. I refuse to cut residential lawns
    bi-weekly and I refuse to cut lower than 3 1/2 inches. People who want these things usually don't care one bit about you or your equipment. I have stuck to my guns on both these issues for the entire seven years I have been in business. I will let a lawn go every single time I get the lower and less often question.

Share This Page