deck building question /code

Discussion in 'Hardscaping' started by ccas, Jul 30, 2013.

  1. ccas

    ccas LawnSite Member
    Posts: 102

    Just throwing this out there. I'm sure some if you do your fair share of deck building.
    I'm hoping to add a section to my deck. The only problem is that the heater vents run right where my deck would go. I'm guessing I couldn't put a bend in them or run them under the deck???
     
  2. trock

    trock LawnSite Senior Member
    Posts: 430

    Dont run it under the deck if something gets in it it would be hard to clean. Aslo run the risk of the pipe icing up in the winter.
     
  3. DVS Hardscaper

    DVS Hardscaper LawnSite Fanatic
    Posts: 6,403

    "Heater vents"?

    Or do you mean dryer vents??

    By code, dryer vents are not allowed to have any more than one or two 90-degree bends. Which most likely it already has them. I forget the exact code, but I know a code does exist.
     
  4. ccas

    ccas LawnSite Member
    Posts: 102

    No. Dryer is on 2nd floor. I believe they are from the water heater and the furnace.
     
  5. jbailey52

    jbailey52 LawnSite Bronze Member
    Posts: 1,061

    So yes, he meant "heater vents"
     

Share This Page