Deck height sticker missing 2008 Laser Z

Discussion in 'Lawn Mowing' started by Kev68ss, Jun 15, 2011.

  1. Kev68ss

    Kev68ss LawnSite Member
    Posts: 5

    Hi Guys-

    Could someone please tell me the height adjustments starting at the bottom hole on a 2008 ExMark Laser Z- 60". I think it has 8 total holes- thanks:confused:
     
    Last edited: Jun 15, 2011
  2. Greg78

    Greg78 LawnSite Silver Member
    Posts: 2,010

    My Lazer is older than yours, IIRC they were all the same until 2009.

    Bottom hole is 1 1/2"" then 1/2" increments to top hole that is 4 1/2", travel position is 5".
     
  3. Kev68ss

    Kev68ss LawnSite Member
    Posts: 5

    Thanks Greg, perfect- I've posted one more question re the mower
     
  4. Runner

    Runner LawnSite Fanatic
    Posts: 13,496

    But there are lines in between for the 1/4" increments.
     
  5. Greg78

    Greg78 LawnSite Silver Member
    Posts: 2,010

    Good to know. Wonder when they changed to that?
     
  6. Kev68ss

    Kev68ss LawnSite Member
    Posts: 5


    So are the holes 1/2"??
     
  7. kenwin30

    kenwin30 LawnSite Member
    Posts: 111

    i bought a lazer z hp a couple of yrs ago, it has the deck holes at 1/2 inch increments, i was wondering if it would be possible to drill a couple of more pin holes for the deck adjustment pin ? i could really use the the 2 3/4 and 3 1/4 hole if it could be done. thanks guys
     
  8. Runner

    Runner LawnSite Fanatic
    Posts: 13,496

    Mine is a 2000, and it goes 1/4" increments. The holes are all staggered.
     

Share This Page