1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

DEWALT 24 volt problem with drill

Discussion in 'Trucks and Trailers' started by meets1, Feb 7, 2011.

  1. meets1

    meets1 LawnSite Gold Member
    Posts: 3,756

    Tear down tomorrow. Thinking transmission
    Posted via Mobile Device
     
  2. rlitman

    rlitman LawnSite Bronze Member
    Posts: 1,501

    Probably. If the clutch were slipping, it would be very noisy.
    I'm not sure of that particular model, but DeWalt's I've repaired before often have a pin that goes through the shaft, which passes power to the gear, and that can break. Just the friction of the shaft on the gear will get the chuck to still turn a bit. If it's just that, it is an inexpensive part (unless you're handy enough to make something yourself), but gearboxes can be more difficult to reassemble than electronics in the original box.
    How on earth to they get all that stuff into the cardboard boxes anyway? [​IMG]
     

Share This Page