Do not mix chain kits and double blades if.....

Discussion in 'Lawn Mowing' started by rvsuper, Apr 19, 2003.

  1. rvsuper

    rvsuper Senior Member
    Posts: 930

    You don't want great stripes! I thot just my chainkit did good, well this morning I threw on doubles and the stripes are great!!

    Everyone post pictures of the stripes you so far have this year.

    stripes 001.jpg
     
  2. rvsuper

    rvsuper Senior Member
    Posts: 930

    Here is another one. You can see where it goes from my lawn to the neighbors lawn there. These are kind of crooked, my mower doesn't have a small turning radius so I have to back up several times, which leads to them to be a little crooked.

    stripes 010.jpg
     
  3. rvsuper

    rvsuper Senior Member
    Posts: 930

    Last one for now. Here is one of the whole yard:

    stripes 012.jpg
     
  4. FrankenScagMachines

    FrankenScagMachines LawnSite Platinum Member
    from IN
    Posts: 4,739

    Yeah! Thats what I'm talking about. Thats from an Ariens RER right? Pretty good.....

    apr18266.jpg
     
  5. FrankenScagMachines

    FrankenScagMachines LawnSite Platinum Member
    from IN
    Posts: 4,739

    The last pic was a 32" ex-RER with a single high lift and a deck roller (striping roller). All these are with the Scag 52" hydro with doubles (gator over high lift) and striping flap.

    apr18282.jpg
     
  6. FrankenScagMachines

    FrankenScagMachines LawnSite Platinum Member
    from IN
    Posts: 4,739

    .

    apr18288.jpg
     
  7. bastalker

    bastalker LawnSite Senior Member
    Posts: 965

    Very nice Rv, an BHB!!!!:drinkup:
     
  8. FrankenScagMachines

    FrankenScagMachines LawnSite Platinum Member
    from IN
    Posts: 4,739

    ,

    apr18289.jpg
     
  9. FrankenScagMachines

    FrankenScagMachines LawnSite Platinum Member
    from IN
    Posts: 4,739

    It only gets better bastalker but thanks!

    apr19299.jpg
     
  10. FrankenScagMachines

    FrankenScagMachines LawnSite Platinum Member
    from IN
    Posts: 4,739

    In the above pic you can see the lines of clippings because I was mulching with the OCDC down, tall growth. I always mow that section with OCDC down because there's so many trees and usually just double cut to get it all mulched up good and for striping- it's very high visibility area!

    apr19306.jpg
     

Share This Page