Double blades on a Super Z

Discussion in 'Lawn Mowing' started by loborojo338, Apr 1, 2005.

  1. loborojo338

    loborojo338 LawnSite Member
    Posts: 20

    I was just wondering if there is any one out there running double blades on a Super Z,or is it even possible? I have a 28 EFI with a 60 inch deck.
     
  2. Shady Brook

    Shady Brook LawnSite Bronze Member
    from Indiana
    Posts: 1,517

    I have used doubles many times on my Super Z. If you do not want to effect cutting height, put the offset blade on top, and your blade of choice below and you will be the same height. Any combo not using an offset, or an offset on the bottom will throw off your height setting which you can cure with some spacers. Doubles work very well on my Super Z to be sure.

    Good luck
     
  3. Axl

    Axl LawnSite Member
    Posts: 233

    do you use a longer bolt? How bout an blade coupling or do you just put one on top of the other?
     
  4. Shady Brook

    Shady Brook LawnSite Bronze Member
    from Indiana
    Posts: 1,517

    The bolt is plenty long, and just stack the blades together and torque them down. I use an air wrench, and they will not move unless you really dig into the ground or a stump. It is best to avoid doing this if possible! :rolleyes: :)
     

Share This Page