Doubles On 260Z

Discussion in 'Gravely (Archived)' started by John Gamba, Aug 19, 2002.

Thread Status:
Not open for further replies.
  1. John Gamba

    John Gamba LawnSite Fanatic
    from ct
    Posts: 10,812

    Hi gravely
    Do you have A double Blade Kit for your 260 Z Mid mount yet.
    Are the blades Cutting at the same height On Your Double Blade kits On Your other mowers. And are the Blades On the same Cutting height As the blades If You Are Runnig just one Per spindal.

    Thank you Johnny G.
     
  2. The Gladiator

    The Gladiator Member
    Posts: 70

    Hi John,
    Well, the answer to your question is not on our current models. If we were to install the double blade kits on the 50" ~ 72" decks, the blades would set below the leading edge of the deck and not allow us to pass the ANSI specification that we choose to adhear to because of legal reasons.

    We may in the near future choose to release the double blade kits for our new product. (Stay tooned)
    As for blade cutting edges they will not run on the same plain thus giving you two different cutting plains which really aids to chop up the grass.

    Regards,
    Dan Kilgas
     
  3. John Gamba

    John Gamba LawnSite Fanatic
    from ct
    Posts: 10,812

    The Blades On the same Hight Don't seam To have blow out As Much. But They Do work For choping Up The Grass.

    Will this New Product Be before Spring 2003?

    Thank You John Gamba Lawnone
     
  4. The Gladiator

    The Gladiator Member
    Posts: 70

    John, We will be introducing the new product to our dealers second week of Sept. Soon after you will see new product literature and info on our web site.

    Regards,
    Dan
     
  5. John Gamba

    John Gamba LawnSite Fanatic
    from ct
    Posts: 10,812

    THANK'S DAN
    My first mower Was a gravely And I Still Have It.
    John
     
  6. The Gladiator

    The Gladiator Member
    Posts: 70

    Thanks for being so loyal to the product. We've made some great improvement for the new product for 2003. Stay tooned!

    Dan
     
Thread Status:
Not open for further replies.

Share This Page