Drive belts is loose

Discussion in 'Mechanic and Repair' started by googles, Jun 24, 2004.

  1. googles

    googles LawnSite Senior Member
    Posts: 294

    One of my drive belt is loose on my toro 36". how do i tighten the belt so it doesnt keep sliding to the right? The drive belt on the other side works fine and stays tight. please help its driving me nuts. ;)
     
  2. googles

    googles LawnSite Senior Member
    Posts: 294

    Can anybody help? :)
     
  3. WigginsLandscaping

    WigginsLandscaping LawnSite Member
    Posts: 103

    You should have two rods going from your T-Bar. One on each side. At the bottom of those rods is a threaded end that is attached with a pin. Remove the pin and rotate the end to make the distance longer betweed the top of the rod to the adjustable end. Put the pin back on and repeat on both sides. Once adjusted you should have about an inch or so between the frame and the t-bar. Now you will need to adjust parking brake. Each side has another rod at the bottom that also has a pin. At the top of that rod is a wingnut. You will need to tighten this one ( I believe). Repeat on other side.
     

Share This Page