1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

EB 802 wiring problem

Discussion in 'Mechanic and Repair' started by A&R Enterprise, Nov 14, 2012.

  1. A&R Enterprise

    A&R Enterprise LawnSite Member
    Posts: 96

    I found out today why my eb 802 does not want to shut off .the wiring from the switch isnt right.I traced it back to the engine side for the wiring.Ive got 2 black wires with bullet nose connectors just laying there.Could someone tell me where these wires hook too or show me a picture of the wiring that goes in the back of the motor or under the carb,Thanks
  2. BigFish

    BigFish LawnSite Gold Member
    Posts: 3,255

    You should have two wires coming off the coil, bottom of motor, behind the gas tank. One is a ground wire, the other is the kill wire. They get hooked to the wires leading to the kill switch on the control lever.
  3. A&R Enterprise

    A&R Enterprise LawnSite Member
    Posts: 96

    got it fixed ........Thanks

Share This Page