Electric Brake Pod Not Working

Discussion in 'Trucks and Trailers' started by Frosty_03, Mar 18, 2003.

  1. Frosty_03

    Frosty_03 LawnSite Senior Member
    Posts: 333

    Can anyone give any info on why my electric brake pod for my trailer is not working. I checked for power and it is gettting power, it is just not working. I thought the pod was bad so I went and traded it in on another one. Still the same nothing no power once again. The lights, turning signals and brake lights work fine. If anyone can help be much appreciated.
    :help:
     
  2. Lombardi

    Lombardi LawnSite Senior Member
    Posts: 538

    Have you traced the wiring from the trailer brakes all the way to the front of the trailer? There could be a break or maybe it was never wired in at the factory.
     
  3. Frosty_03

    Frosty_03 LawnSite Senior Member
    Posts: 333

    I looked up under there, but it was getting late so I will do that tomorrow, thanks for the info. Here is picture of it all loaded up
     
  4. HOw about a pic of the "POD".......
     
  5. Frosty_03

    Frosty_03 LawnSite Senior Member
    Posts: 333

    Thanks for your info I check the break wires on the trailer and sure enough lombardi there was a cut wire. So once again I say thanks. Since I was there already I took the hubs off and packed the barrings and check the wear on the magnets everything seem to working just fine. I think this is a very good site because there is very valuable infomation here. I owe you one Lombardi. Thanks a million!!!!:blob2:

    GOD SPEED AND REMEMBER OUR TROOPS!!!!!!
     

Share This Page