Emptying the camera

Discussion in 'Irrigation' started by FIMCO-MEISTER, May 20, 2008.

  1. Had some pics stored up I needed to delete
    I got on a good buddy for doing this. Ran a tee right next to a driveway and set a head on a cutoff nipple. Guess what? It broke when it got run over! WELL DUHHHHH

    DSC00897.jpg
     
  2. .......................

    DSC00898.jpg

    DSC00899.jpg
     
  3. Customer who has never seen a spot that couldn't use a hanging basket. We did as well as we could. Used 1/4" copper.

    DSC00900.jpg

    DSC00901.jpg

    DSC00902.jpg

    DSC00903.jpg

    DSC00904.jpg
     
  4. hoskm01

    hoskm01 LawnSite Fanatic
    Posts: 5,690

    Nice boots, whoever that is. Par the course.
     
  5. EagleLandscape

    EagleLandscape LawnSite Platinum Member
    Male, from Garland, Texas
    Posts: 4,347

    henry?????????

    how was the dia meeting tonight? almost went, but had too many proposals to turn out.
     
  6. CAPT Stream Rotar

    CAPT Stream Rotar LawnSite Fanatic
    Posts: 5,959

    Nice pics peter!!!

    Fantastic!

    I love the 1/4 copper tubing! how did you fasten it to the brick?
     
  7. We used these clear 1/4 plastic conduit holders and flute anchors. Customer is going to have the house painted. I wanted to make sure we never had to do this job again which is why I went copper plus it will stay rigid and not sag. Henry and I love a challenge. When I have a cr-ppy job I go with the best material and spare no expense. I thought about cutting a groove in the mortar to recess the copper but decided that might lead to structural damage.
     
  8. NC_Irrigator

    NC_Irrigator LawnSite Bronze Member
    from NC
    Posts: 1,416

    i agree, nice boots!
     
  9. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Posts: 48,014

    Nice stream rotor breakdown. I save a few parts from the old ones I remove, and they've come in handy.
     
  10. EagleLandscape

    EagleLandscape LawnSite Platinum Member
    Male, from Garland, Texas
    Posts: 4,347

    I met John today out at Oak Tree. Nice guy.
     

Share This Page