enclosed trailer interior lighting

Discussion in 'Trucks and Trailers' started by johnyredd99, Mar 5, 2012.

  1. johnyredd99

    johnyredd99 LawnSite Member
    from gap,pa
    Posts: 163

    I am looking for some info on how to go about lighting the interior of enclosed trailer while not hooked to truck. and/or being able to run 110 lights and fan while hooked up. I have done a search and older post that I found was not much help.... i understand that watts/amps+lumens-volts=the lights come on.
    I know others w/ enclosed have to have problems w/ lack of lighting. so this is what i need help w/...

    i have wired trailer so i can plug in like a camper to household current. running an extension cord is not always practical nor is trailer always hooked to truck for the 12v lighting.
    my thoughts are to install car battery in trailer, hook inverter to battery, inverter plugs into main line for lights..(2 2ft flouresants, ten inch fan, phone charger)
    now to charge car battery in trailer....can i hook into break-away battery? or do i have to charge at home?
    would I be better to put inverter under hood of truck and run a cord?
    do i not get inverter at all...just install battery and splice into 12volt lights? again how to charge battery?

    does anyone else run into the same problem of not being able to see inside when not hooked up to truck? what have you done to fix it?

    thanks
     
  2. knox gsl

    knox gsl LawnSite Platinum Member
    Posts: 4,848

    You can get 12 volt flouresant lights or can use 12 volt 4" LED round lights. I used to run a foodservice route and thats what we had inside of our trailers.
    Posted via Mobile Device
     
  3. ecurbthims

    ecurbthims LawnSite Senior Member
    Posts: 467

    I would run just 12 volt lights with a battery ,and a rooftop solar panel ,as well as a wire from your marker lights to charge the battery .I would run a deep cycle battery .Running an inverter is not efficient as you end up losing power just to run the inverter .
     
  4. johnyredd99

    johnyredd99 LawnSite Member
    from gap,pa
    Posts: 163

    I never thought of solar panel idea. Im going to look into that. thank you.
    I am wondering how running a wire from my marker lights will charge battery?
     
  5. ecurbthims

    ecurbthims LawnSite Senior Member
    Posts: 467

    when you run down the road ,turn on your marker lights ,and the battery will charge while you drive .
     
  6. ParkWelding

    ParkWelding LawnSite Member
    Posts: 182

    Why wouldn't you just use the +12V wire in your 7 blade trailer plug to charge your battery?
     
  7. Trailer Parts Superstore

    Trailer Parts Superstore Inactive
    Posts: 129

  8. johnyredd99

    johnyredd99 LawnSite Member
    from gap,pa
    Posts: 163

    i have the interior lighting installed. I have 4 12v running along ceiling and 1 in cabinet. I also have 2 18inch flouresent lights and 4 outlets run together to exterior socket. kind of the same idea as 'shore power' for rv's boats.

    from what i am gathering so far is, and please correct me if im wrong.....

    12volt wires from truck side to trailer side

    run to positive side deep cycle battery? battery ground to frame.
    ---by running wire to battery like this will charge battery w/o stand alone batt charger?

    now run from positive side batt. to 12v interior lights.
    ---by do it this way i will be able to run my 12v lights both while connected and disconnected from tow vehicle?

    thank you for help
     
  9. johnyredd99

    johnyredd99 LawnSite Member
    from gap,pa
    Posts: 163

    like this. I would think there would need to be a batt charger along the way

    12v wiring.jpg
     
  10. Ray&Christine

    Ray&Christine LawnSite Member
    Posts: 181

    I'm not sure how much light you need but I have 2 recharable LED work/trouble lights. They are are not bright enough to read a book in the trailer but bright enough to find someting on a shelf or so you don't trip over your mowers.
     

Share This Page