Encore Pro-48 Wb kill switch?????

Discussion in 'Mechanic and Repair' started by localhero800, Aug 19, 2009.

Tags:
  1. localhero800

    localhero800 LawnSite Member
    Posts: 9

    dads been out with the mower
    and ive been had surgery, so i havent got a chance to get a pic, but how would i wire a kill switch that would run on a lanyard that cliped to your belt, so when the mower got away, it would pull the pin and kill the mower??? any ideas?
    db
     
  2. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024

    Simple,

    The lanyard switch has two wires, Hook one to the kill wire going to the ignition coil and the other to a good ground.

    If the lanyard pulls off the switch it grounds the coil killing spark and shutting the engine down.
     
  3. localhero800

    localhero800 LawnSite Member
    Posts: 9

    where would i get one of these at????

    db
     
  4. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024

    Hahaha.....I just knew you would ask that !


    HERE . [​IMG]
     
  5. localhero800

    localhero800 LawnSite Member
    Posts: 9

    im sorry im bein such a apain, but im not suppoed to leave the house till saturday, due to my surgery, but where would i find the wire to tap into the coil? my mower has a Kohler CV-20 on it.

    thanks for all the help!!! you dont know how big of a help you`ve been!!!!

    db
     
  6. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024

    Naaa, Not a pain......

    Should be able to tap into the wire marked "M" on the back of the ignition switch.

    Best of luck getting back out doors.....
     

Share This Page