Engine Died

Discussion in 'Mechanic and Repair' started by coocoobird, Aug 7, 2011.

  1. coocoobird

    coocoobird LawnSite Member
    Posts: 13

    Hey all basically i have a Husqvarna cz4817 with a Kohler CV490s Motor. The engine made a clunk and died. I tore the engine down and found the piston rod had shattered. It did no other damage luckily. So i ordered a new rod for the engine that will be here in a few days. I was wondering if there is a timing procedure i would have to do on it. This is my first time being inside a mower engine as i am use to building car engines. Thanks for the help!
     
  2. Aled Owen

    Aled Owen LawnSite Member
    Posts: 1

    If you've had experience rebuilding car engines then a mower engine should be no suprised. Unless you've taken the timing gears out of the crankcase there shouldn't be any need to do any timing procedures. If you only taken the conrod out and that's all then all you need to do is put in the new one.
     
  3. coocoobird

    coocoobird LawnSite Member
    Posts: 13

    Thanks for the info! thats what i needed to know. :cool2:
     

Share This Page