1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

Engine HP required for running Doubles

Discussion in 'Lawn Mowing' started by Bunton Guy, Oct 15, 2001.

  1. Flex-Deck

    Flex-Deck LawnSite Silver Member
    Posts: 2,846

    I dont think doubles would affect the belt enough to not run them. I think you may have a had a problem before that just had not shown up yet.
  2. Bunton Guy

    Bunton Guy LawnSite Bronze Member
    Posts: 1,755

    Do I need a special holder for the blades or do I just stack them on there and hold them in place when tightning them ?
  3. vipermanz

    vipermanz LawnSite Bronze Member
    Posts: 1,773

    Bunton Guy; if you have a single bolt confuguration that's the way to go , if you a have a dbl+ config. a bracket will be required
  4. 65hoss

    65hoss LawnSite Fanatic
    Posts: 6,360

    Bunton Guy, just stack them and tighten. Once you get them partially tight they will not move anymore. I run a high lift on bottom and gator on top. Try different ways and find out for your mower which does better. You don't need any type of special setup.

Share This Page