Engine Rebuild

Discussion in 'Mechanic and Repair' started by Kkane97, Jul 6, 2012.

  1. Kkane97

    Kkane97 LawnSite Senior Member
    Posts: 676

    15 mysig wont show im on my phone
    Posted via Mobile Device
     
  2. BigFish

    BigFish LawnSite Silver Member
    Posts: 2,919

    Ah, grasshopper, that's a horse of a different color!
    I see your signature says 15. Duh!
    Anyways, it's great that your learning and working on your own stuff! Cool!
    But since your in the learning mode, it's best to learn the right way to do things, as opposed to the halfa$$ed way! ( no offense Dad!)
    Hey, there's plenty of good advice ( along with some bad) on this site that comes from true "legends in their own minds" as well as good mechanics! ( I hate the word techni......)
    So.... next time ya got a project to work on, ask, ask, ask, before you tear into that puppy. ( if ya did in any previous posts, I musta missed em)

    Generally, before I tear into an engine for a rebuild I usually do the following:
    1. Pressure wash / clean it externally.
    2.Pull the muffler and carb and check for any oil in either.
    3.Pull the plug and check ( kinda goes without saying)
    4. Check the valve clearance.( for the next step)
    5. Do a leakdown test. OR use an airline with a rubber tipped blowgun AND a regulator to push air in the cyl and check for any leaks. ( more on that later)
    6. Rotate the flywheel away from the coil ( if still attached) and shake it back and forth to check for excessive radial play or shake. Too much and you know right off the bat that you've got major problems.
    7. Grab the PTO end of the crank and push and pull to check for excessive end-play

    Some mechanics do more, some less.

    The actual rebuild can get pretty involved at times.( If done the right way)

    I'm hoping that some of the other mechanics can guide you thru the other steps involved.

    One things for sure, you need to get your grubby paws on a shop/service manual for WHATEVER yer workin' on!

    Keep up the good work!

    And hey, don't mind me.......I don't like anybody!!!!
     
    Last edited: Jul 7, 2012
  3. Kkane97

    Kkane97 LawnSite Senior Member
    Posts: 676

    Thanks for the recommendations, I definitly learned my lesson and would much rather learn the right way to do things instead of the way that will "just work" :)
     
  4. Patriot Services

    Patriot Services LawnSite Fanatic
    Posts: 12,450

    Did you check the gap between the tappets and the valve stem?
    Posted via Mobile Device
     

Share This Page