1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

Exmark Lazer Z not engaging blades

Discussion in 'Mechanic and Repair' started by 12Valve, Jun 1, 2009.

  1. 12Valve

    12Valve LawnSite Member
    from NC
    Posts: 115

    Started mowing thismoening and noticed that when I enguaged the blades it acted a little diff like not bogging down the mower as much, just a minute ago I went to lift the deck up to mow over a rock and she quit tuning them. I didn't hit the rock something broke before I got to the rock. Ive been enguage/dissenguage at 1/2 throtte like it says. Any idea's all belts are on go to pull the yellow knob and I get notta.

    THEGOLDPRO LawnSite Fanatic
    Posts: 5,223

    could be the yellow knob, i had one go bad one time on me, and it wouldent engage the blades, could also be the clutch, how many hours are on the machine?
  3. 12Valve

    12Valve LawnSite Member
    from NC
    Posts: 115

    68.8 hours I took it to dealer thisafternoon. Hopefully know something tommorow
  4. DT Lawn Care

    DT Lawn Care LawnSite Senior Member
    Posts: 850

    Check your fuses. It should be one of them. If not, probably your switch, or unfortunately, your clutch.

Share This Page