Exmark Metro I.D. and maint. question

Discussion in 'eXmark' started by Bamafire1, Apr 1, 2004.

  1. Bamafire1

    Bamafire1 LawnSite Member
    Posts: 26

    I have an older exmark metro. I would like to know how old it is. The model # is M36-12.5K-5 and serial # 102883.

    Also, I cannot get a short enough cut. All the spacers have been placed to the shortest position but it is still not short enough. It cuts at about 2 inches. How can I adjust it further?

    Thirdly, how can I get a hard copy of the owner's and operator's manual for this mower?

    Thanks,

    Bamafire1
     
  2. eXmark

    eXmark Manufacturer / Sponsor
    Posts: 4,258

    Bamafire1,

    That's a 1995 model. You can cut as low as 1" with that model. You'll need to raise the rear axle to the lowest position, move all the blade spacers below the spind and move all the caster spacers to the top.

    If you send me a pm along with your name and address I'll have our service department send out the correct manuals asap. Just to make sure nothing gets confused (or I don't get confused) you may want to include your seral number in the e-mail.

    Thanks,

    Terry
     

Share This Page