Exmark pulley removal

Discussion in 'Lawn Mowing' started by jbutch83, May 22, 2003.

  1. jbutch83

    jbutch83 LawnSite Member
    Posts: 89

    Just purchased a ultravac, and everything was going good on the install. Then we had to remove the pulley, and we can't get the thing to budge. We have soaked it, heated it, you name it, it will not move. Am I missing something, or does someone have any ideas on how to get this thing off.

    Thanks,

    John
     
  2. John Gamba

    John Gamba LawnSite Fanatic
    from ct
    Posts: 10,812

    John
    You Should Put this Question In Exmarks Forum.
    John G.
     
  3. jbutch83

    jbutch83 LawnSite Member
    Posts: 89

    Sorry, I wasn't sure where to post it. Is there anyway to transfer, or do I need to repost.

    John
     
  4. J&R

    J&R LawnSite Senior Member
    Posts: 835

    The pulley has a set screw. you will need to back it off to remove the pulley.
     
  5. John Gamba

    John Gamba LawnSite Fanatic
    from ct
    Posts: 10,812

    I Just Put One On a 2002 And Two On A 2001's And there where No Set Scew?I Would Just Post It In Exmarks Forum, Tell Terry Johhny G. Sent Yeah!
    John.
     

Share This Page