1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

Exmark Sulky

Discussion in 'eXmark' started by TJLC, Sep 5, 2001.

  1. TJLC

    TJLC LawnSite Bronze Member
    Posts: 1,308

    I just purchased a used (in VERY good cond.) Exmark sulky for my 48" Exmark Viking Hydro. It was $300.00 installed. My question is: Is there any special tips that I need to know about this sulky ?
    Thanks for any help.
  2. eXmark

    eXmark Manufacturer / Sponsor
    Posts: 4,258


    Congratulations. That's a pretty good deal if you compare it to the price of a new on. The Sulky is a fairly basic piece of equipment so maintenance is fairly straightforward. Lubricate all grease points daily and the wheel bearings once per week. I might also recommend a good tire sealant as well.

    Just remember not to exceed the 15-degree maximum slope angle and slow down until you get used to operating your mower with the sulky.

    Good luck

  3. TJLC

    TJLC LawnSite Bronze Member
    Posts: 1,308

    Terry, thank you for getting back to me so quickly. TJLC

Share This Page