Exmark Turf Tracer 48''

Discussion in 'Lawn Mowing Equipment' started by LawnMan19, Dec 29, 2012.

  1. LawnMan19

    LawnMan19 LawnSite Gold Member
    Posts: 3,284

    Hey, I need some advice could anyone tell me how to disengage the hydros on a Turf Tracer to be able to move it without running the engine or damaging the hydros.
    Thanks
     
  2. LawnMan19

    LawnMan19 LawnSite Gold Member
    Posts: 3,284

    Anyone????
     
  3. RodneyK

    RodneyK LawnSite Senior Member
    Posts: 753

    I think there is a nut on the hydros to turn that releases them.
     
  4. LawnMan19

    LawnMan19 LawnSite Gold Member
    Posts: 3,284

    Thanks a lot man.
     
  5. sjessen

    sjessen LawnSite Gold Member
    Male, from Knoxville, Tn
    Posts: 3,053

    Yes, as stated above, each pump has a dump valve which looks like a nut on a bolt on the back of the bump. Loosening that will relieve the pressure. When retightening be careful to avoiding getting them too tight.
     
  6. LawnMan19

    LawnMan19 LawnSite Gold Member
    Posts: 3,284

    Thank you very much, I know their had to be something but had no clue. I appreciate it a lot man
     
  7. sjessen

    sjessen LawnSite Gold Member
    Male, from Knoxville, Tn
    Posts: 3,053

    You are quite welcome!! Glad to be of some help.
     
  8. LawnMan19

    LawnMan19 LawnSite Gold Member
    Posts: 3,284

    You're a great help, now I don't need to spend a whole day trying to figure it out.
     
  9. RodneyK

    RodneyK LawnSite Senior Member
    Posts: 753

  10. LawnMan19

    LawnMan19 LawnSite Gold Member
    Posts: 3,284

Share This Page