Exmark wanting to cut out

Discussion in 'Lawn Mowing' started by shorty7616, May 22, 2004.

  1. shorty7616

    shorty7616 LawnSite Member
    Posts: 230

    I was using my Exmark Metro yesterday and it seemed like every little bump i went over it wanted to die out. I removed the belt cover,and it didn't do it as much, but still alittle. Oh, and it only does this when the blades are on.

    Any ideas?

    Could the Operator Presence Control have a bad wire?
     
  2. azurevirus

    azurevirus LawnSite Member
    Posts: 1

    dont know much about the commercial stuff but I would ck for a bad electrical connection maybe on the blade disengagement switch on my troy if I had that prob...sounds electrical to me anyways.
     
  3. MikeLT1Z28

    MikeLT1Z28 LawnSite Bronze Member
    Posts: 1,732

    hey shorty, where in tn are you? sounds like a definite OPC problem. there is a wire on the kohlers (not sure about the kawi's) right by the throttle linkage. mine was loose and causing the same problem. i fixed it by putting a wire tie around the metal plate and connector. that was last year and it's been fine since.
     
  4. chuckwk

    chuckwk Founder
    from KC, MO
    Posts: 634

    Did you post this question in the eXmark forum here at LawnSite.com ??
     

Share This Page