1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

ferris 36" blade wont start

Discussion in 'Mechanic and Repair' started by tnt625, May 30, 2007.

  1. tnt625

    tnt625 LawnSite Member
    Posts: 1

    hello,i have a belt driven ferris 36".today while i was cutting a lawn the blade stopped.i flicked switch on & off a few times,but nothing.took to local repair shop,they suggested replacing switch,which they didnt have of course.i located one & purchased and installed it but still nothing.the blade wont move when its on but if i release handle it stalls out (safety feature)like it is running.i'm looking for any help i could get,
    thanks tim
     
  2. khouse

    khouse LawnSite Bronze Member
    Posts: 1,465

    You need to see if there is battery voltage at the clutch wire when it's engaged. Then we all can go from there.
     

Share This Page