For Peter: Irritrol MC-Plus - Eicon Connection

Discussion in 'Irrigation' started by PurpHaze, May 8, 2007.

  1. PurpHaze

    PurpHaze LawnSite Fanatic
    Posts: 5,496

    Here's how the receiver connects to the controller's circuit board when the pigtail hasn't been installed.

    Irritrol-Eicon Connection IV-01.jpg

    Irritrol-Eicon Connection IV-02.jpg

    Irritrol-Eicon Connection IV-03.jpg

    Irritrol-Eicon Connection IV-04.jpg
     
  2. Remote Pigtails

    Remote Pigtails LawnSite Senior Member
    Posts: 581

    Gotcha. I take it you have extensions for the round black part.
     
  3. PurpHaze

    PurpHaze LawnSite Fanatic
    Posts: 5,496

    The round connector (connects the receiver's wiring to the pigtail) is out of site in the pictures.
     
  4. Remote Pigtails

    Remote Pigtails LawnSite Senior Member
    Posts: 581

    The third pic down I can see a little bit of wire. Makes sense now.
     
  5. PurpHaze

    PurpHaze LawnSite Fanatic
    Posts: 5,496

    Yeah... that's where the round connector is. It was 5:30 this morning when I took the pictures and couldn't see the LCD screen very well. I'll take a better picture tomorrow. :)
     
  6. PurpHaze

    PurpHaze LawnSite Fanatic
    Posts: 5,496

    OK Peter... better picture of how it all goes together. :)

    Irritrol-Eicon Connection IV-05.jpg

    Irritrol-Eicon Connection IV-06.jpg
     
  7. CAPT Stream Rotar

    CAPT Stream Rotar LawnSite Fanatic
    Posts: 5,959

    thats pretty sweet Purp
     
  8. Remote Pigtails

    Remote Pigtails LawnSite Senior Member
    Posts: 581

    i sent an e-mail pic. I think my plug in for the six prong is going to be spaced okay but the prongs on that irritrol may be bigger than the holes in my plug in. I'm going to just go ahead and check on that. Hopefully my prototype will work.
     
  9. PurpHaze

    PurpHaze LawnSite Fanatic
    Posts: 5,496

    I aint getting a micrometer out! Maybe the prototype will match up. We'll find out. :)
     

Share This Page