Front Rotor

Discussion in 'Trucks and Trailers' started by allabout, Feb 3, 2001.

  1. allabout

    allabout LawnSite Member
    Posts: 54

    Is it a big job to remove & replace front rotor (95 2WD.)3500
     
  2. thelawnguy

    thelawnguy LawnSite Silver Member
    Posts: 2,412

    If its a C&C (tube axle):

    Drop the wheel, remove the caliper, remove the 1 13/16 nut from the axle stub, get the snap-on adapter that bolts to the studs, and screw on your monster mother---'in slide hammer. It will come off in about six whacks.

    If its a pickup (IFS):

    Just like any other RWD vehicle; remove the nut and off it comes bearings and all.
     
  3. allabout

    allabout LawnSite Member
    Posts: 54

    It's a 1 ton dump with 4 nut's on back side & I think about 6 or 8 on front after tire is removed. Thanks. (very rusted bolts.)
     
  4. thelawnguy

    thelawnguy LawnSite Silver Member
    Posts: 2,412

    But is it tube axle or independent suspension?

     
  5. allabout

    allabout LawnSite Member
    Posts: 54

    I think it's tube axle. does the rotor come off with the wheel barring.
     
  6. plowking35

    plowking35 LawnSite Bronze Member
    from S.E. CT
    Posts: 1,687

    If its like a gm, and I think it is. You will need to remove that entire assembly, then the rotor unblots from the hub assembly. They make them two piece to save money so you dont have to buy the entire dually offset assembly.
    Remove the assembly like Bill mentioned, and then unblot the rotor from the hub. The studs are pressed in like a wheel stud. Once off, reverse proceedure to reinstall.
    Dino
     
  7. allabout

    allabout LawnSite Member
    Posts: 54

    Driver side rotor is off the other rotor will not come off lots off rust sprayed it & let it sit overnight let's hope that works.
    Thanks for the help.
     

Share This Page