1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

GIE+EXPO Demo MAG-9000 available

Discussion in 'Magna-Matic' started by Magna-Matic, Nov 5, 2009.

  1. Magna-Matic

    Magna-Matic Sponsor
    Posts: 828

  2. wright5223

    wright5223 LawnSite Senior Member
    Posts: 290

    Any 8000's around? I demo one and loved it, They said to check back after the show!
     
  3. Magna-Matic

    Magna-Matic Sponsor
    Posts: 828

  4. mtchockey30

    mtchockey30 LawnSite Member
    from Midwest
    Posts: 231

    How much are they used during the show? Do you put a new wheel on it or keep the same one on it?
     
  5. Magna-Matic

    Magna-Matic Sponsor
    Posts: 828

    Hello

    It varies from year to year what the show discounts will be, and its different for demo units sold in out of the booth that were used at the show. The wheels have little wear after a weekend of demonstrations, but the additional or extra wheel is negotiable at the show.

    I'm sorry I don't have a more specific answer, we keep the show discounts to reward people for coming to the show and visiting us, and as I mentioned it varies from year to year.
     
  6. mtchockey30

    mtchockey30 LawnSite Member
    from Midwest
    Posts: 231

    I have a question about the sharpeners, what direction does the stone turn when sharpening the blade? I was told it was different then most of the other blade sharpeners.
     
  7. Magna-Matic

    Magna-Matic Sponsor
    Posts: 828

    Hello,

    When you are looking at the face of the wheel, our grinding wheel turns clockwise. If you look at my avatar, or the banner above during the grinding pictures where sparks are coming off you can see that the sparks come up off the blade edge and shoot into the grit guards. This is done so there is no chance for the wheel to pinch the blade. It is specified that industrial grinders must push a work piece away not suck it in, in the case that the operator lets go of the work piece.

    All of our competitors have dual direction motors, they do this so they can sharpen both right and left-handed lawn mower blades. This is unsafe because if the operator didn't pay attention to which way they turned the machine on, they could pinch the blade between the worktable and grinding wheel.

    The reason sometimes that people think that our wheel is turning a different direction than our competitors is because they are using the competitors machine incorrectly. Doing a right-handed blade on our competitors machine should also be rotating clockwise, however because they do not include safety guards, the sparks shoot up at the ceiling without those additional guards. So people will put the wheel direction so it sharpens downward pinching the blade against the worktable (THIS IS VERY DANGEROUS). But they will do this because then the sparks go downward under the worktable.

    Magna-Matic using ONLY single direction motors, as specified by ANSI and OSHA (safety organizations) to meet industrial safety standards. Please keep in mind that the lawn care industry is not considered "industrial" so our competitors do not have to abide by these standards. This is why they can offer the grit guards (safety guarding) as OPTIONAL EQUIPMENT, and use dual direction motors, basic nuts to hold the grinding wheels on, rather than approved ARBORS. Magna-Matic designs all products to industrial safety standards, for YOUR benefit.

    If you compare, you'll find our competitors will be more expensive if you add all the safety guarding and tools that we provide WITH the SHARPENER.
     

Share This Page