Governor

Discussion in 'Mechanic and Repair' started by Butch1957, Nov 7, 2005.

  1. Butch1957

    Butch1957 LawnSite Member
    Posts: 106

    On a 8hp. Briggs Horizontal Shaft ( M-190432 T-6035 ) how would one set/adjust the governor lever/shaft for this type of unit ?

    Any suggestions ?

    Please Respond !

    Thanks.
     
  2. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,022

    Grab the gov. arm and move it to the wide open throttle position (NOTE) which direction the gov. shaft rotates when moved to full throttle, While holding at full throttle Loosen the pinch screw on the arm and rotate the shaft the same direction until it stops. Hold a slight pressure on the shaft while tightening the pinch screw.
     
  3. Butch1957

    Butch1957 LawnSite Member
    Posts: 106

    Thanks for the Input There Amigo ! Greatly appreciated & works Great according to your Specs.

    Thanks Again.
     

Share This Page