1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

Grandstand Bagger

Discussion in 'Toro' started by delphied, Jul 23, 2009.

  1. lilweeds

    lilweeds LawnSite Senior Member
    Posts: 595

    yes!!!!!!!!!!!
     
  2. The Toro Company

    The Toro Company LawnSite Senior Member
    Posts: 354

    Delphied -
    Toro GrandStand mowers accept the same soft bagger used on our walk-behind midsize mowers. This bagger, model 30104, is readily available for dealers to order.

    Thank you,
    The Toro Company
     
  3. brucec32

    brucec32 LawnSite Platinum Member
    Posts: 4,403

    What was the problem with the accelerator? I have used the Exmark cloth bagger (same as Toro) on ztrs and wb's and it's ok but nothing special.
     
  4. delphied

    delphied LawnSite Silver Member
    Posts: 2,067

    The Accelerator works well but it weighs a ton even though it is aluminum. Mine is the biggest they make. My cloth bagger when full is all I care to dump into a bag.
     
  5. Bob_n_weave

    Bob_n_weave LawnSite Senior Member
    Posts: 375

    I use the Operator- Controlled- Discharge-Chute on my Grandstand which comes in very handy for not blowing Grass Clippings in unwanted area's.

    My question is: Is there a Bagging System that will work with the Operator Controlled Discharge Chute attached ? Don't want to Bag the whole yard, just around Tree's to pick up Leaves.

    Toro ?
     
  6. AA+ landscaping

    AA+ landscaping LawnSite Member
    Posts: 208

    yes ( bob n weave) you can use the bag with the operator controlled chute attached. I have the 48in you have to put it under battery box. Note: i didn't like it at all it left grass in piles when close.
     
  7. The Toro Company

    The Toro Company LawnSite Senior Member
    Posts: 354

    Bob_n_Weave -

    We haven't installed a bagger and OCDC kit together. The OCDC kit does not stop the chute from being flipped up / backward, and the Toro side bagger installation instructions direct the operator to flip the chute up vs. removing the chute. So it would seem to reason that the bagger should mount to the deck if the chute and ODCD rubber paddle are flipped up. Obviously the bagger would need to be removed to use the OCDC again, but it should allow you to go back and forth between the two attachments on an as needed basis.

    -Then Toro Company
     
  8. becpropertymaint.

    becpropertymaint. LawnSite Senior Member
    Posts: 313

    so any new word on a bigger bagger for the grandstand
     
  9. The Toro Company

    The Toro Company LawnSite Senior Member
    Posts: 354

    becpropertymain -

    While it remains a goal to develop a larger, custom designed bagger for the Toro GrandStand, we don't have anything to announce for the 2010 spring and summer season.

    -The Toro Company
     
  10. Bob_n_weave

    Bob_n_weave LawnSite Senior Member
    Posts: 375


    PLEASE make it a goal to develop a bagging system that works without having to remove the O.C.D.C.

    The O.C.D.C. is a must have and to much a hassle to be taking on and off every time you want to bag a little.

    When you flip up the discharge chute the rubber flap that opens/close's gets in the way preventing the bagging system from attaching, including the Accelerator :(
     

Share This Page