1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

Grass Gobbler welding

Discussion in 'Lawn Mowing' started by BufalinoLand, Feb 3, 2005.

  1. BufalinoLand

    BufalinoLand LawnSite Senior Member
    Posts: 400

    My grass gobbler has seen better days, too much rubbing on concrete. How do I weld such brital and perferated metal. is it possible or buy a new one.

    thanks Joe
  2. lwcmattlifter

    lwcmattlifter LawnSite Senior Member
    from NC
    Posts: 859

    Mine has wore out about the same. I welded 1/8 flat stock over the areas where the previous welds broke and patched a hole in the side. I'm going to buy an Accelerator to replace the grassgobbler hopefully by leaf season.

Share This Page