Grease type to use for ZTR???

Discussion in 'Lawn Mowing' started by Vibe Ray, May 23, 2001.

  1. Vibe Ray

    Vibe Ray LawnSite Senior Member
    Posts: 785

    What type of grease should I use on the fittings for my Lazer HP (Remember, no spindle greasing necessary)? Would any type of grease work better than another? Right now I just use some grease I had in the garage. Thanx!!!
  2. 65hoss

    65hoss LawnSite Fanatic
    Posts: 6,360

    I use the valvoline semi synthetic.
  3. racerdave

    racerdave LawnSite Senior Member
    Posts: 260

    I use the same thing 65hoss uses. It's a little pricey but I like the stuff.
  4. SMB

    SMB LawnSite Senior Member
    Posts: 323

    Right now I'm using a generic lithium grease, but I hope to get some of the "red "lubrimatic" brand grease, that stuff's good grease.
  5. edward hedrick

    edward hedrick LawnSite Senior Member
    Posts: 871

    I use Wolfs head red. My Toro was 13 years same spindle bearings.
  6. jasonp

    jasonp LawnSite Member
    from Alabama
    Posts: 147

    I use Mobil 1 semi syntheic, seems to work pretty good. As long as you grease often looks like any grease would work ok.
  7. Barkleymut

    Barkleymut LawnSite Bronze Member
    Posts: 1,117

    Be sure to use an EP rated grease, especially in spindle bearings.
  8. Keith

    Keith LawnSite Gold Member
    Posts: 3,977

    I used to use Amsoil, but switched to Quaker State FCI. The Amsoil seemed to dry out. The QS is cheaper too.
  9. thelawnguy

    thelawnguy LawnSite Silver Member
    Posts: 2,412

    FWIW Exmark recommends not using a lithium base grease in their spindle assemblies. Wonder why?
  10. Ground Pounder

    Ground Pounder LawnSite Member
    Posts: 112

    I use John Deere Turf Guard. It is a blue grease formulated for high moisture. I've never seen blue grease until my dealer hooked me up with this stuff.

Share This Page