Greasing Lazer Z HP

Discussion in 'Homeowner Assistance Forum' started by Larry Davis, Feb 3, 2005.

  1. Larry Davis

    Larry Davis LawnSite Member
    Posts: 116

    I have always had a difficult time properly greasing the rear drive pulley and wondered if anyone could offer a suggestion to make this task easier. This is the grease fitting on the pulley that you must lift the seat to access. Most times I have trouble gettting the tip of my grease gun to properly fit onto the grease zerk due to the size of the access hole. Any ideas?
     
  2. sgoalie23

    sgoalie23 LawnSite Member
    Posts: 195

    Our grease guns have extension hose which can allow for an extra foot of reach. Try to add an extension hose. Hope I helped you out a little bit.

    Brian
     
  3. 65hoss

    65hoss LawnSite Fanatic
    Posts: 6,360

    I know what you are talking about. He isn't talking about extension to reach it. He is talking about the end not fitting right due to the hole. On by HP's I've taken a wrench and turned them down. That way when I do anything under the mower I just hit it with grease. Real easy then. It is not threaded in all the way, so there is plenty of room to make a 1/2 turn more to get it turned down.
     
  4. Larry Davis

    Larry Davis LawnSite Member
    Posts: 116

    Thanks 65hoss. That's exactly what my problem is. I'll do as you suggest.
     

Share This Page