Hall of hacks & pikers Photo's please.

Discussion in 'Irrigation' started by Buck_wheat, Oct 29, 2010.

  1. Sprinkus

    Sprinkus LawnSite Silver Member
    Posts: 2,099

    Nice nozzle, bad install of it. :rolleyes:

    CIMG0449.JPG
     
  2. Mike Leary

    Mike Leary LawnSite Fanatic
    Posts: 21,896

    Yup, WM nozzle, RB riser, got to be very careful threading them, obviously.
     
  3. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Posts: 47,315

    that's the special low-angle nozzle setting :)
     
  4. Mike Leary

    Mike Leary LawnSite Fanatic
    Posts: 21,896

    As in any brass to plastic, at first, I rotate backwards until I feel the brass thread drop into the plastic. Going forward right away is asking for a cross thread.
     
  5. Autoflow

    Autoflow LawnSite Member
    Posts: 245

    Exactly what I do, and on the odd occasion you get the PITA client who is standing over your shoulder and says "You are going the wrong way!"

    I came across this interesting valve box a few days ago. I think it was a home owner job judging by this and the 2" pop ups in the lawn areas.

    pot valve box (Small).JPG
     
  6. jvanvliet

    jvanvliet LawnSite Gold Member
    Posts: 3,939

    Hope no one has to spin any of those valves out.
     
  7. alf500series

    alf500series LawnSite Senior Member
    Posts: 257

    Posted via Mobile Device
     
  8. Sprinkus

    Sprinkus LawnSite Silver Member
    Posts: 2,099

    Blowed out pipe. :rolleyes:
    Why is it so difficult for people to use primer and the right glue on flex pipe? :wall

    CIMG0456.JPG

    CIMG0457.JPG
     
  9. 1idejim

    1idejim LawnSite Fanatic
    Posts: 9,308

    i theorize that if you don't need primer then why would they make it?
     
  10. NC_Irrigator

    NC_Irrigator LawnSite Bronze Member
    from NC
    Posts: 1,415

    We use clear primer and clear cleaner...
     

Share This Page