Hand held blowers hard to start when its hot

Discussion in 'Mechanic and Repair' started by ddixon7, Dec 23, 2011.

  1. dutch1

    dutch1 LawnSite Silver Member
    from Jayhawk
    Posts: 2,231

    Slapper, I've seen 2 or 3 that had warped isoblocks same as you did. Have seen 3 or 4 pieces that the isoblock was cracked, but the evidence didn't show up until the unit was hot, then would not restart.
     
  2. piston slapper

    piston slapper LawnSite Platinum Member
    Posts: 4,240

    Dutch
    The stuff I've been working on would never be taken to a repair shop.
    If I can't fix it then it becomes parts or scrap.
    Some of the isoblocks were so loose that they had grooves in them from the cylinder.
    Its hard to imagine that they could run that long with an air leak that bad.
    Posted via Mobile Device
     

Share This Page