1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

Help wiring break controller

Discussion in 'Trucks and Trailers' started by T. Wheeler, May 14, 2006.

  1. T. Wheeler

    T. Wheeler LawnSite Member
    Posts: 130

    Well I have a 1997 GMC 1500 Suburban and I have all the wires hooked up to the brake controller, except the stop light switch (brake light switch). I can not find it anywhere. Is there any place to access it easily?

  2. aklandscape

    aklandscape LawnSite Member
    Posts: 40

    Look at your brake pedal and follow it up under the dash. There should be a little plunger type switch either in front of or in back of the brake pedal high on the pedal up under the dash and put a test light on the wires one at a time while pushing on the brake pedal. It should light up only when you push the brake pedal.
  3. oldrustycars

    oldrustycars LawnSite Senior Member
    Posts: 301

    the switch will have a red wire and a white wire. you want the white one.
  4. T. Wheeler

    T. Wheeler LawnSite Member
    Posts: 130

    Great thinks I found it finally. Now gotta adjust

Share This Page