1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

help with lazer wiring

Discussion in 'Mechanic and Repair' started by chesterlawn, Apr 23, 2008.

  1. chesterlawn

    chesterlawn LawnSite Senior Member
    Posts: 708

    I bought a used lazer model lz27lka604 ser. 332144 and it ran fine until today. Went to start it nothing, would not turn over. Turned key on and jumped wire to starter selinoid and it started, but when I enguaged clutch it it acted wierd. So I replaced pto switch , now it starts but when I release the brake or pull stearing levers in it dies. If I take off the kill relay I can run it fine but shuts off because of no fuel. Why does it keep dying, can I bypass the safty switches? The mower came with the seat switch bypassed.
  2. chesterlawn

    chesterlawn LawnSite Senior Member
    Posts: 708

    Nevermind, when I changed the pto switch, the seat module harness came loose. Just pushed it back tight and it runs fine.

Share This Page