Help With Sulky Attachment

Discussion in 'Lawn Mowing' started by jennylee, Jan 17, 2010.

  1. jennylee

    jennylee LawnSite Member
    Posts: 2

    Hi I'm buying a GR1332 pro walk with a rear discharge, I would like to get a sulky attachment also but wonder if I would need to change it to a side discharge? Also was there much fabrication involved in fitting the Wright sulky?

    Any info much appreciated.

    Happy mowing!
    JE
     
  2. MikeKle

    MikeKle LawnSite Platinum Member
    Posts: 4,253

    You can use a sulky with a rear discharge, and all that is needed for the wright sulky is to drill the holes in the mowers frame for the mounting coupler, or I guess you could weld it on, but best to drill holes in case you want to remove it later. good luck.
     
  3. jennylee

    jennylee LawnSite Member
    Posts: 2

    thanks for reply Mike!
    I post my progress
     
  4. silverado212

    silverado212 LawnSite Senior Member
    Posts: 373

    Your hitch should be 11 1/4" from the ground to the center of the grease fitting.
     
  5. STIHL GUY

    STIHL GUY LawnSite Fanatic
    from CT
    Posts: 5,225

    i would bolt it so you can take it off later down the road if you wish to
     

Share This Page