Help

Discussion in 'Lawn Mowing' started by pcs, Apr 29, 2001.

  1. pcs

    pcs LawnSite Member
    Posts: 198

    I'm trying to take my blades off of my walker ghs deck. I can't get them off. Do you have to go the oppisite way because one of the blades go the oppisite way?
     
  2. cantoo

    cantoo LawnSite Silver Member
    Posts: 2,910

    No they are normal, make sure you use a wooden block to hold the blade from turning. It will make it easier to get some leverage, next time put some grease on the threads.
     
  3. awm

    awm LawnSite Gold Member
    Posts: 3,354

    i highly recommend the 12 volt impact wrench .
    you can get them on ebay for 39.95 most of the time.
    i also use a jump starter to plug into but the cord on these are pretty long(PLUGS INTO CIG LIGHTER)
    dont worry it is strong enough to take a rusted
    nut off.luck to you
     
  4. captdevo

    captdevo LawnSite Senior Member
    Posts: 932

    turn left to loosen, right to tighten

    do not over tighten when you are replacing.

    Torque to 60ft-lbs. only. or you will defeat the purpose of the shear bolts.
     
  5. Fantasy Lawns

    Fantasy Lawns LawnSite Bronze Member
    Posts: 1,913

    this is when an impact wrench really helps .....when your by your self ....no need to block the blades ....be sure to put a few drops of oil on the nut or threads when putting it back on .....just helps in removal
     

Share This Page